6302DDUC3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100760896

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Seal Type	Contact Seals
Lubricant	Mul-Temp SRL
Inner Ring Width	13 mm
Cage Type	Metal
Precision	Standard
I.D.	15 mm
Precision Level	Standard (ABEC 1)
Ball Material	Steel
Outer Ring Width	13 mm
Snap Ring	No Snap Ring
Preload Level	None
O.D.	42.0000 mm
icNumber	7696033
Corner Radius [Min]	1.00 mm
Cage Material	Pressed Steel
Locking Device	No Locking Device
Bore Type	Round Bore
Radial Internal Clearance Specification	Greater Than Normal Clearance
Limiting Speed - Grease	13000 rpm
Inch/Metric	Metric Bore
Capacity	Standard Capacity
Enclosure	Double Sealed
O.D. Type	Straight
Seal Material	Buna-N
Limiting Speed - Oil	20000 rpm
Dynamic Load Rating	2,570.00 lbf
Contact Angle	0°
Material	Steel
Bearing Type	Radial
No. in Set	Single Bearing
Static Load Rating [Max]	1,220.00 lbf
Rows of Balls	Single
Radial Internal Clearance	C3
Width	13 mm
Weight	0.181 LB
EAN or UPC	29176065361