6302DDUC3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100760896

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Width	13 mm
Dynamic Load Rating	2,570.00 lbf
Inch/Metric	Metric Bore
Ball Material	Steel
I.D.	15 mm
O.D.	42.0000 mm
Seal Material	Buna-N
Bearing Type	Radial
Cage Material	Pressed Steel
No. in Set	Single Bearing
Radial Internal Clearance	C3
Snap Ring	No Snap Ring
Inner Ring Width	13 mm
Locking Device	No Locking Device
Limiting Speed - Oil	20000 rpm
Static Load Rating [Max]	1,220.00 lbf
Limiting Speed - Grease	13000 rpm
Material	Steel
Capacity	Standard Capacity
Lubricant	Mul-Temp SRL
Corner Radius [Min]	1.00 mm
Rows of Balls	Single
O.D. Type	Straight
Precision	Standard
Precision Level	Standard (ABEC 1)
icNumber	7696033
Cage Type	Metal
Seal Type	Contact Seals
Preload Level	None
Bore Type	Round Bore
Enclosure	Double Sealed
Contact Angle	0°
Outer Ring Width	13 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Weight	0.181 LB
EAN or UPC	29176065361