Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 7/8-14 UNF-2B SAE O-Ring Port
- 7.32 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
options
- SAE ports
- Splined and tapered shafts
| Rotation | Standard Rotation |
| Seal Material | Buna-N |
| Special Features Hardware Code | 00 |
| Series | H Series |
| Special Features | None |
| Output Torque at Rated PSI (inch/pounds) | 1699 in lb |
| RPM [Min] | 469 rpm |
| Splines | 0 |
| Shaft Size & Type | 1 in x 1/4 in Straight |
| Case Drain | 0.4375-20 UNF-2B SAE O-Ring Port (End Cap) |
| Port Size | SAE-10, 7/8-14 UNF-2B |
| Bolt Circle Dia. | 4.187 in |
| Mount Type | 2 Bolt |
| Paint/Packaging | Primer Low Gloss Black, Individual Box |
| Shaft Type | Straight w/ Woodruff Key |
| Flange Orientation | Standard |
| Port Location | Side Port |
| Motor Type | Spool Valve |
| Port Code | A |
| Maximum Speed @ Continuous Flow | 469 rpm @ 15 gal/min |
| Pressure [Max] | 1800 psi |
| Motor Element | Gerotor |
| Output Shaft Code | 01 |
| Flow [Max] | 15 gal/min |
| Flow Rate | 14 gal/min |
| Case Drain Code | 1 |
| Mounting Type Code | A |
| Mounting Holes | 0.535 in |
| Corrosion Resistant | No |
| Duty | Standard-Duty |
| Paint Code | A |
| Port Type | SAE O-Ring |
| Material | Cast Iron |
| Mounting Hole Size | 0.565 in |
| RPM [Max] | 469 rpm |
| Pilot Diameter | 3.25 in |
| Inlet Pressure [Max] | 2500 psi |
| Special Features Assembly Code | 0 |
| Displacement (in³/rev) | 7.32 |
| Port Size & Location | SAE-10 Side |
| Weight | 12.67 LB |
