Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 7/8-14 UNF-2B SAE O-Ring Port
- 8.91 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
| Output Torque at Rated PSI (inch/pounds) | 1956 in lb |
| Case Drain | None |
| RPM [Min] | 385 rpm |
| Corrosion Resistant | No |
| Shaft Size & Type | 1 in - 6T Spline |
| Splines | 6 |
| Port Size | SAE-10, 7/8-14 UNF-2B |
| Inlet Pressure [Max] | 2500 psi |
| Maximum Speed @ Continuous Flow | 385 rpm @ 15 gal/min |
| Flange Orientation | Standard |
| Seal Material | Buna-N |
| Port Location | Side Port |
| Material | Cast Iron |
| Special Features Assembly Code | 0 |
| Special Features Hardware Code | 00 |
| Special Features | None |
| Port Type | SAE O-Ring |
| Output Shaft Code | 02 |
| RPM [Max] | 385 rpm |
| Motor Element | Gerotor |
| Pressure [Max] | 1700 psi |
| Mount Type | 2 Bolt |
| Port Size & Location | SAE-10 Side |
| Mounting Hole Size | 0.565 in |
| Displacement (in³/rev) | 8.91 |
| Port Code | A |
| Case Drain Code | 0 |
| Motor Type | Spool Valve |
| Series | H Series |
| Flow [Max] | 15 gal/min |
| Pilot Diameter | 3.25 in |
| Paint Code | A |
| Paint/Packaging | Primer Low Gloss Black, Individual Box |
| Rotation | Standard Rotation |
| Mounting Holes | 0.535 in |
| Mounting Type Code | A |
| Duty | Standard-Duty |
| Flow Rate | 14 gal/min |
| Bolt Circle Dia. | 4.187 in |
| Shaft Type | Splined |
| Weight | 12.4 LB |
