Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 7/8-14 UNF SAE O-Ring Port
- 9.7 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
| Displacement (in³/rev) | 9.7 |
| Rotation | Standard Rotation |
| Mount Type | 4 Bolt |
| Motor Element | Gerotor |
| Pilot Diameter | 1.75 in |
| Material | Cast Iron |
| Paint Code | A |
| Port Code | A |
| RPM [Max] | 353 rpm |
| Flow Rate | 15 gal/min |
| Flow [Max] | 15 gal/min |
| Mounting Hole Size | 3/8 in |
| Case Drain | None |
| Splines | 6 |
| Case Drain Code | 0 |
| Duty | Standard-Duty |
| Maximum Speed @ Continuous Flow | 353 rpm @ 15 gal/min |
| Output Torque at Rated PSI (inch/pounds) | 2062.22 in lb |
| Shaft Type | Splined |
| Port Location | Side Port |
| Special Features Hardware Code | 00 |
| Mounting Type Code | B |
| Inlet Pressure [Max] | 2500 psi |
| Output Shaft Code | 02 |
| Special Features | None |
| Pressure [Max] | 1650 psi |
| Special Features Assembly Code | 0 |
| Paint/Packaging | Low Gloss Black, Individual Box |
| Port Type | SAE O-Ring |
| Motor Type | Spool Valve |
| Port Size & Location | SAE-10 Side |
| Series | H Series |
| Mounting Holes | 3/8-16 |
| Corrosion Resistant | No |
| Flange Orientation | Standard |
| Port Size | SAE-10, 7/8-14 UNF |
| Seal Material | Buna-N |
| Bolt Circle Dia. | 3 1/4 in |
| Shaft Size & Type | 1 in - 6T Spline |
| Weight | 12.5 LB |
