Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 1/2-14 NPTF Port
- 9.7 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
| Mount Type | 2 Bolt |
| Motor Type | Spool Valve |
| Material | Cast Iron |
| RPM [Min] | 353 rpm |
| Rotation | Standard Rotation |
| Flow [Max] | 15 gal/min |
| Case Drain Code | 0 |
| Series | H Series |
| Duty | Standard-Duty |
| Flow Rate | 14 gal/min |
| Splines | 0 |
| Special Features | None |
| Output Torque at Rated PSI (inch/pounds) | 2062 in lb |
| Port Location | Side Port |
| RPM [Max] | 353 rpm |
| Inlet Pressure [Max] | 2500 psi |
| Port Type | NPTF |
| Seal Material | Buna-N |
| Port Size & Location | 1/2 in NPTF Side |
| Motor Element | Gerotor |
| Port Size | 1/2, 1/2-14 |
| Mounting Type Code | A |
| Paint/Packaging | Primer Low Gloss Black, Individual Box |
| Maximum Speed @ Continuous Flow | 353 rpm @ 15 gal/min |
| Paint Code | A |
| Shaft Type | Straight w/ Cross Hole |
| Bolt Circle Dia. | 4.187 in |
| Output Shaft Code | 08 |
| Displacement (in³/rev) | 9.7 |
| Special Features Hardware Code | 00 |
| Pilot Diameter | 3.25 in |
| Shaft Size & Type | Straight |
| Special Features Assembly Code | 0 |
| Mounting Hole Size | 0.565 in |
| Port Code | B |
| Corrosion Resistant | No |
| Case Drain | None |
| Mounting Holes | 0.535 in |
| Pressure [Max] | 1650 psi |
| Flange Orientation | Standard |
| Weight | 12.5 LB |
