Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 7/8-14 UNF SAE O-Ring Port
- 9.7 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
options
- SAE ports
- Splined and tapered shafts
| Motor Element | Gerotor |
| Pressure [Max] | 1650 psi |
| Port Type | SAE O-Ring |
| Inlet Pressure [Max] | 2500 psi |
| Paint/Packaging | Low Gloss Black, Individual Box |
| Pilot Diameter | 3.25 in |
| Case Drain Code | 1 |
| Duty | Standard-Duty |
| Output Shaft Code | 01 |
| Port Size & Location | SAE-10 Side |
| Port Size | SAE-10, 7/8-14 UNF |
| Displacement (in³/rev) | 9.7 |
| Mounting Hole Size | 0.535 in |
| Mount Type | 2 Bolt |
| Shaft Size & Type | 1 in x 1/4 in Straight |
| Flow [Max] | 15 gal/min |
| Mounting Type Code | A |
| Special Features | None |
| Port Location | Side Port |
| Case Drain | 0.4375-20 UNF-2B SAE O-Ring Port (End Cap) |
| Bolt Circle Dia. | 4.19 in |
| Shaft Type | Straight w/ Woodruff Key |
| Maximum Speed @ Continuous Flow | 353 rpm @ 15 gal/min |
| Special Features Hardware Code | 00 |
| Motor Type | Spool Valve |
| Port Code | A |
| Seal Material | Buna-N |
| RPM [Max] | 353 rpm |
| Special Features Assembly Code | 0 |
| Output Torque at Rated PSI (inch/pounds) | 2062.22 in lb |
| Corrosion Resistant | No |
| Series | H Series |
| Splines | 0 |
| Material | Cast Iron |
| Paint Code | A |
| Rotation | Standard Rotation |
| Flange Orientation | Standard |
| Mounting Holes | 0.535 in |
| Flow Rate | 15 gal/min |
| RPM [Min] | 353 rpm |
| Weight | 13.0 LB |
