Find a Service Center
- Spool Motor
- Gerotor
- Spool Valve
- 7/8-14 UNF SAE O-Ring Port
- 9.7 Cubic Inch Displacement Per Rev
description
- Small but powerful, Eaton spool valve motors have the perfect combination of features for a variety of demanding applications, from harvesting equipment to food processing plants. With hydrodynamic journal bearings optimized for long life, these spool valve motors distribute pressurized fluid via integrated valve slots into the Gerotor or Geroler® orbit gear set. This results in a spool valve section that can be optimized for low-flow low-speed requirements, keeping equipment performing smoothly.
applications
- Agricultural augers, Harvesters, Seeders, Industrial sweepers and floor polishers
features
- Integrated proven orbit motor principle results in a compact yet powerful package
- Hydrodynamic journal bearings extend bearing life
- Three-zone pressure design allows for an increased shaft seal and bearing life
| Maximum Speed @ Continuous Flow | 353 rpm @ 15 gal/min |
| Special Features Hardware Code | 00 |
| Flow Rate | 15 gal/min |
| Special Features | None |
| Rotation | Standard Rotation |
| Seal Material | Buna-N |
| Special Features Assembly Code | 0 |
| Series | H Series |
| Motor Element | Gerotor |
| Port Code | A |
| Port Size | SAE-10, 7/8-14 UNF |
| Pilot Diameter | 3.25 in |
| Bolt Circle Dia. | 4.19 in |
| Output Torque at Rated PSI (inch/pounds) | 2062.22 in lb |
| Displacement (in³/rev) | 9.7 |
| Shaft Size & Type | 1 in - 6T Spline |
| Paint/Packaging | Low Gloss Black, Individual Box |
| Splines | 6 |
| Corrosion Resistant | No |
| Port Type | SAE O-Ring |
| RPM [Max] | 353 rpm |
| Inlet Pressure [Max] | 2500 psi |
| Case Drain Code | 0 |
| Pressure [Max] | 1650 psi |
| Material | Cast Iron |
| Mounting Hole Size | 0.535 in |
| Mounting Holes | 0.535 in |
| Mounting Type Code | A |
| Case Drain | None |
| Port Size & Location | SAE-10 Side |
| Output Shaft Code | 02 |
| Port Location | Side Port |
| Shaft Type | Splined |
| Motor Type | Spool Valve |
| Duty | Standard-Duty |
| Mount Type | 2 Bolt |
| Flange Orientation | Standard |
| Paint Code | A |
| Flow [Max] | 15 gal/min |
| Weight | 12.5 LB |
