6313DDUC3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100761527

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

O.D.	140.0000 mm
Seal Type	Contact Seals
Lubricant	Mul-Temp SRL
Seal Material	Buna-N
Limiting Speed - Grease	3400 rpm
Outer Ring Width	33 mm
Material	Steel
I.D.	65 mm
Radial Internal Clearance	C3
Corner Radius [Min]	2.10 mm
Contact Angle	0°
Bore Type	Round Bore
Ball Material	Steel
Precision Level	Standard (ABEC 1)
Locking Device	No Locking Device
Radial Internal Clearance Specification	Greater Than Normal Clearance
Preload Level	None
Precision	Standard
No. in Set	Single Bearing
Inner Ring Width	33 mm
Rows of Balls	Single
O.D. Type	Straight
Limiting Speed - Oil	6000 rpm
icNumber	7696260
Capacity	Standard Capacity
Static Load Rating [Max]	13,450.00 lbf
Cage Type	Metal
Inch/Metric	Metric Bore
Bearing Type	Radial
Cage Material	Pressed Steel
Dynamic Load Rating	21,835.00 lbf
Snap Ring	No Snap Ring
Enclosure	Double Sealed
Width	33 mm
Weight	4.72 LB
EAN or UPC	29176065934