6303DDUC3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100760932

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

Seal Material	Buna-N
Contact Angle	0°
Locking Device	No Locking Device
Inner Ring Width	14 mm
Enclosure	Double Sealed
Bearing Type	Radial
Material	Steel
Snap Ring	No Snap Ring
Dynamic Load Rating	3,060.00 lbf
Inch/Metric	Metric Bore
Static Load Rating [Max]	1,490.00 lbf
icNumber	7695875
Capacity	Standard Capacity
O.D. Type	Straight
O.D.	47.0000 mm
Precision	Standard
Ball Material	Steel
Cage Type	Metal
Limiting Speed - Oil	18000 rpm
Corner Radius [Min]	1.00 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Width	14 mm
Limiting Speed - Grease	11000 rpm
I.D.	17 mm
Precision Level	Standard (ABEC 1)
Seal Type	Contact Seals
Outer Ring Width	14 mm
Radial Internal Clearance	C3
Cage Material	Pressed Steel
Bore Type	Round Bore
Preload Level	None
Rows of Balls	Single
No. in Set	Single Bearing
Lubricant	Mul-Temp SRL
Weight	0.249 LB
EAN or UPC	29176065408