6319DDUC3

HPS – High Performance Standard 6300 Series Single Row Deep Groove Ball Bearing

Item #100761695

Auto Replenish

each One-time purchase

Product Details

Deep groove radial bearings are manufactured as open type bearings for oil or grease lubrication. They are also available with metal shields and/or seals for use where moderate contamination is present in the operation.

Complies with RoHS restrictions on the use of certain hazardous substances in electrical and electronic equipment
For deep groove ball bearings, if the bearing load is too small during operation, slippage occurs between the balls and raceways, which may result in smearing
The higher the weight of balls and cage, the higher this tendency becomes, especially for large bearings
If very small bearing loads are expected, please contact Applied® for selection of an appropriate bearing

Specifications

O.D. Type	Straight
Snap Ring	No Snap Ring
Inch/Metric	Metric Bore
O.D.	200.0000 mm
Rows of Balls	Single
Seal Type	Contact Seals
Cage Type	Metal
No. in Set	Single Bearing
Limiting Speed - Oil	3600 rpm
Enclosure	Double Sealed
Precision Level	Standard (ABEC 1)
Cage Material	Pressed Steel
Ball Material	Steel
Width	45 mm
Radial Internal Clearance Specification	Greater Than Normal Clearance
Corner Radius [Min]	3.00 mm
Lubricant	Mul-Temp SRL
I.D.	95 mm
Contact Angle	0°
Limiting Speed - Grease	2400 rpm
Static Load Rating [Max]	26,700.00 lbf
Seal Material	Rubber
Precision	Standard
Inner Ring Width	45 mm
Locking Device	No Locking Device
Capacity	Standard Capacity
Dynamic Load Rating	36,116.00 lbf
Radial Internal Clearance	C3
Bore Type	Round Bore
Bearing Type	Radial
Material	Steel
Outer Ring Width	45 mm
Preload Level	None
Weight	12.83 LB
EAN or UPC	29176066115