Find a Service Center
- 3" Center Distance
- 40:1 Ratio
- C-Face Coupled
- Left Output
- 140TC/180C Frame
features
- Rugged housing fabricated of fine-grained cast iron for maximum strength and greater precision during worm and gear alignment
- Bronze worm gear is straddle mounted between heavy-duty tapered roller bearings to increase thrust and load capacities on size 713 to 760
- Housing is straddle milled top and bottom for precise alignment
- Internal baffles ensure positive, leak-free venting
- High strength steel output shaft ensures capacity for high torque
- Pipe plugs allow easy fill, level and drain in any mounting position
- Super finished oil seal diameters on both input and output shafts extend seal life
- Large oil reservoir provides efficient heat dissipation and lubrication for longer life
caution
- Tags shall be used as a means to prevent accidental injury or illness to employees who are exposed to hazardous or potentially hazardous conditions, equipment or operations which are not readily apparent. Tags shall be used until such time as the identifi
- Tags shall contain a signal word and a major message.
- Danger tags indicate an imminently hazardous situation which, if not avoided, will result in death or serious injury. The signal word Danger is to be limited to the most extreme situations. Danger tags should not be used for property damage hazards unless
- Note: A tag shall not be used in place of a permanent sign or label intended for hazards in normal use, operation or maintenance.
| Torque Out @ 1750 rpm | 2041 in lb |
| Fan Cooled | No |
| Box Length | 8 1/8 in |
| Base to Centerline of Output Shaft | 3 1/4 in |
| Family Name | RF |
| Worm Position | Universal |
| Output (Shaft or Bore) Size | 1 1/4 in |
| Ratio | 40:1 |
| Box Width | 6 49/64 in |
| Input Configuration | C-Face Coupled |
| Max. Thrust Load @ RPM | 1000 lb/in @ 1150 rpm, 1000 lb/in @ 1750 rpm |
| Lubrication | None |
| Input HP @ RPM | 1.46 hp @ 1150 rpm, 1.78 hp @ 1750 rpm |
| Output Configuration | Left Output |
| Housing Material | Cast Iron |
| Box Height | 8 7/8 in |
| Reduction Type | Single Reduction |
| Output RPM @ 1750 rpm Input | 43.75 rpm |
| Torque Out @ 1150 rpm | 2470 in lb |
| Motor Application | General Purpose |
| Output Torque @ RPM | 2041 in lb @ 1750 rpm, 2470 in lb @ 1150 rpm |
| Use With | 730 |
| Washdown Duty | No |
| Frame | 140TC, 180C |
| Output RPM @ Input RPM | 44 rpm @ 1750 rpm |
| Input (Shaft or Bore) Size | 7/8 in |
| Frame Size | 140TC, 180C |
| Base to Centerline of Input Shaft | 6 1/4 in |
| Max. Thrust Load @ 1150 rpm | 1000 lb/in |
| HP @ RPM | 1.5 hp @ 1800 rpm |
| Center Distance | 3 in |
| Thermal Input Horsepower @ 1750 RPM | N/A |
| Bolt Center | 7 in x 4 in |
| Max. Overhung Load @ 1750 rpm | 1250 lb/in |
| Max. Overhung Load @ RPM | 1250 lb/in @ 1150 rpm, 1250 lb/in @ 1750 rpm |
| Weight | 66.1 LB |
| EAN or UPC | 781711607695 |
